cancel
Showing results for 
Search instead for 
Did you mean: 
Hapoy
New member
1 0 0 0
Message 1 of 3
93
Flag Post
HP Recommended

scan &copy are black blank.

HP Photosmart 5520

I try to make a document copy ,but it came out like all black blank. I follow some of the instruction but still the same, I can print if is from the computer, but if I want just to make a copy of document t doesn't work.

2 REPLIES 2
tbags30
New member
1 1 0 0
Message 2 of 3
54
Flag Post
HP Recommended

scan &copy are black blank.

My HP office jet 4650 will print from computer but when I try to make photo copy just get blank paper. Paper is just as white as when loaded in printer. Any suggestions?

Reply
0 Kudos
HP Support Agent
HP Support Agent
18,344 18,252 1,046 1,150
Message 3 of 3
29
Flag Post
HP Recommended

scan &copy are black blank.

@tbags30

 

Welcome to HP support community.

 

Clean the ink cartridges

  1. Make sure to load the input tray with plain, white paper.

  2. On the printer control panel, swipe the display to the left, then touch Setup.

  3. Touch Tools, then touch Clean Cartridges.

    The printer prints a Print Quality Diagnostic report.

    Image: Example of the Print Quality Diagnostic report

Manually clean the area around the ink nozzles

  1. Gather the following materials:

    • Dry foam-rubber swabs, lint-free cloth, or any soft material that does not come apart or leave fibers (coffee filters work well)

    • Distilled, filtered, or bottled water (tap water might contain contaminants that can damage the ink cartridges)

         CAUTION: 

      Do not use platen cleaners or alcohol to clean the ink cartridge contacts. These can damage the ink cartridge or the printer.

  2. Turn on the printer, if it is not already on.

  3. Gently grasp the handles on either side of the printer, then raise the ink cartridge access door until it locks into place.

    The carriage moves to the center of the printer.

    Image: Opening the ink cartridge access door.

  4. Wait until the carriage is idle and silent before you continue.

  5. Disconnect the power cord from the rear of the printer.

  6. Disconnect the USB cable, if it is connected.

  7. To release the ink cartridge, lift the lid on the ink cartridge slot, then gently push the lid back until it stops.

  8. Pull up on the ink cartridge to remove it from the slot.

       CAUTION: 

    Do not remove both ink cartridges at the same time. Remove and then clean each ink cartridge one at a time. Do not leave an ink cartridge outside the printer for more than 30 minutes.

    1. Lift the lid

    2. Gently push the lid back

    3. Pull up on the ink cartridge

  9. Hold the ink cartridge by its sides.

    Image: Hold the ink cartridge by its sides.

       CAUTION: 

    Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

    Image: Do not touch the contacts or nozzles.

  10. Lightly moisten a foam-rubber swab or lint-free cloth with distilled water, and then squeeze any excess water from it.

  11. Clean the face and edges around the ink nozzle with the swab.

       CAUTION: 

    Do not clean the ink nozzle plate.

    Image: The ink nozzle and ink cartridge contacts.

    1. Nozzle plate - Do not clean

    2. Area surrounding ink nozzle - Do clean

    3. Ink cartridge contacts - Do not clean

  12. Either let the ink cartridge sit for 10 minutes to allow the cleaned area to dry, or use a new swab to dry it.

  13. Hold the ink cartridge by its sides with the nozzles toward the printer, then slide the ink cartridge forward into the slot.

  14. Close the lid on the ink cartridge slot to secure the ink cartridge into place.

    1.  

      Image: Inserting the ink cartridges

      Insert the ink cartridge
    2. Close the lid

    3. The color ink cartridge is on the left, and the black ink cartridge is on the right

  15. Repeat these steps to clean, then reinsert the other ink cartridge.

  16. Close the ink cartridge access door.

  17. Reconnect the power cord to the rear of the printer.

  18. Turn on the printer, if it does not turn on automatically.

  19. Try to print again, and examine the page.

You can refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation