cancel
Showing results for 
Search instead for 
Did you mean: 
Bella31
New member
1 0 0 0
Message 1 of 2
290
Flag Post

I accidentaly restarted my Sprocket during its firmware upgrade and now it's not functioning properl

HP Recommended
Example: hp sprocket 200

I accidentally restarted my Sprocket during its firmware upgrade and now it's not functioning properly. I have tried restarting my phone, and the Sprocket. I attwmpted to disconnect to reconnect and my Sprocket is no longer being detected from my phone 😞 please help

0 Kudos
1 REPLY 1
TEJ1602
HP Support Agent
HP Support Agent
18,899 18,877 1,560 1,569
Message 2 of 2
Flag Post
HP Recommended

@Bella31, Welcome to HP Support Community!

 

Looks like a hardware issue. We can try resetting the printer and try connecting it back. Here is how you do it-

 

You can initiate a factory reset by using the steps below. A factory reset can only be completed when the USB charging cable is NOT connected to the printer.

1. Hold the power button for about 7 seconds in total. After 3 seconds, the Status LED light will turn off to indicate the printer is shutting down; continue to hold the Power button until the LED lights start to flash.

2. Release the power button. The LEDs will continue blinking for about 6 seconds.

3. While the LEDs are blinking, press and release the power button. The device will remain off until you power on again.

4. Power on; the printer will be reset to factoring settings. After a factory reset, all settings are reset to factory defaults (Custom Name, LED color, Sleep Time, Auto-Off, etc.)

 

Hope this helps! Keep me posted. 

 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

TEJ1602
I am an HP Employee

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation