cancel
Showing results for 
Search instead for 
Did you mean: 
JMc1314
New member
1 0 0 0
Message 1 of 2
863
Flag Post

Sprocket wont switch on

HP Recommended
Hp Sprocket

Sprocket shows green fully charged LED.

When switched on White LED comes on for a couple of seconds then goes off.

Sprocket is dead until plugged into charge, shows red LED, after 5 mins shows green fully charged LED.

When switched on White LED comes on for a couple of seconds then goes off etc.

 

I can't switch it on to carry out a reset.

 

Thanks

 

 

0 Kudos
Tags (1)
1 REPLY 1
A4Apollo
Retired
Retired
17,747 17,730 1,301 2,088
Message 2 of 2
Flag Post
HP Recommended

Hi! @JMc1314, Welcome to HP forums.

 

I understand you have issues turning on your sprocket printer.

 

Don't worry I'd like to help you out.

 

Did you make any changes to your printer?

 

Try charging your printer with a different adapter and with a different wall outlet.

 

Please try the steps recommended below.

 

Reset the printer. 

 

1. Turn on the printer.


2. Locate the reset pin-hole near the charging port.


3. Gently insert a straight pin into the hole to press the reset button inside.


4. The printer resets and turns off.


5. Turn on the printer.

 

If the issue still persists after performing reset on the printer. It is a hardware issue please contact HP support for service options.

 

Link to contact HP.

 

 

 

 

Hope this helps!

Have a pleasant day ahead! 🙂

 

A4Apollo
I am an HP Employee

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation