Showing results for 
Search instead for 
Did you mean: 
New member
1 0 0 0
Message 1 of 1
Flag Post

Z840 No GUI after BIOS update. Systems BIOS update to 2.56 also can not make any changes in menu

HP Recommended
Microsoft Windows 10 (64-bit)

The MVMe on my zturbo drive was def. so I replaced it with a new MVMe card. Next I updated the BIOS to v2.56, after that I did a clean

install of Windows 10 including all HP drivers from the HP Support center. When I try to install the Nvida driver for my

Quadro M4000, I noticed that the windows device manager does not see the card. During the driver install the screen went blank, and

the system crashed. After I restarted the system and entered the BIOS, the GUI was no longer there, only a legacy interface.

I can no longer make any changes in the BIOS, when I try it locks up. Also every time I try to install the Nvidia driver the system crashes

and corrupts my Windows installation.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation