Create an account on the HP Community to personalize your profile and ask a question
02-14-2012 06:26 AM
I'm trying to integrate the RMX2000 with CUCM 8.0
from polycom site: I added the CUCM as the sIP server in the IP service and its status in the signaling is ok
what should be done on the CUCM site.
i tried to make a conference with dialing out to Cisco IP phone but it disconnects and in the patricipant properties it gives
"Sip server erorr 503 - 0"
05-24-2012 03:38 AM
you can always check the official documentation => here <=
Page 27 explains the SIP Routing.
Notice: This community forum is not an official HP Poly support resource, thus responses from HP Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge. If you need immediate and/or official assistance please open a service ticket through your support channels.
Please also ensure you always check the General VoIP , Video Endpoint , UC Platform (Microsoft) , PSTN
06-06-2012 01:28 PM
SteffenBaier, thanks for the input but as I said before I've following the document step by step and there is not indication anywhere what to do on the CUCM side for the RMX.
The official document is missing key funtions. There is not section on what to do on CUCM about the RMX. I have multiple settings on the CUCM and I'm not able to register the RMX on CUCM.
I have open a ticket with Polycom, it's just a matter of time until the document is updated.
thanks, any other information will be appriciated.