-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
- HP Community
- Archived Topics
- Desktops (Archived)
- when I try to boot up lighs flash red and computer beeps
Create an account on the HP Community to personalize your profile and ask a question
02-13-2012 06:09 AM
hp compaq d530SFF, windows xp professional, red lights flash and unit beeps upon trying to boot
Solved! Go to Solution.
Accepted Solutions
02-13-2012 06:39 AM - edited 02-13-2012 06:41 AM
Hi:
Here is what I would do...
Turn the PC off and unplug it. Then press the power button to drain any residual power from the motherboard.
1. Remove and reseat the memory module(s). Restart the PC.
2. If removing and reseating the memory module(s) doesn't work, if you have more than one memory module installed, remove all but one, and start the PC.
Test each memory module one at a time, until you find the one that is bad.
If none of that works, check for bulging and leaking capacitors on the motherboard. These may be particularly noticeable around the processor area.
Paul
02-13-2012 06:14 AM
Hi:
There is a pattern to the beep codes.
Look at the table below, and you will find out what your PC is trying to tell you.
Chassis LED and Beep Messages
Power LED # Beeps Event
Steady green None S0 System on (normal operation)
Blinks green @ 0.5 Hz None S1 Suspend
Blinks green @ 0.5 Hz None S3 Suspend to RAM
Off (clear) None S4 Suspend to disk
Off (clear) None S5 Soft off
Blinks red 2 times @ 1 Hz [1] None Processor thermal shutdown
Blinks red 3 times @ 1 Hz [1] None Processor not seated / installed
Blinks red 4 times @ 1 Hz [1] None Power supply failure
Blinks red 5 times @ 1 Hz [1] 5 Memory error
Blinks red 6 times @ 1 Hz [1] 6 Video error
Blinks red 7 times @ 1 Hz [1] 7 PCA failure
Blinks red 8 times @ 1 Hz [1] 8 Invalid ROM checksum (error)
NOTE:
[1] Repeated after 2 second pause
Paul
02-13-2012 06:39 AM - edited 02-13-2012 06:41 AM
Hi:
Here is what I would do...
Turn the PC off and unplug it. Then press the power button to drain any residual power from the motherboard.
1. Remove and reseat the memory module(s). Restart the PC.
2. If removing and reseating the memory module(s) doesn't work, if you have more than one memory module installed, remove all but one, and start the PC.
Test each memory module one at a time, until you find the one that is bad.
If none of that works, check for bulging and leaking capacitors on the motherboard. These may be particularly noticeable around the processor area.
Paul
01-29-2013 12:04 PM
Hello Esther31,
Paul_Tikkanen provided some steps on testing the memory of the computer. Have you tried those steps?
If I have helped you in any way click the Kudos button to say Thanks.
The community works together, click Accept as Solution on the post that solves your issue for other members of the community to benefit from the solution.
- Friendship is magical.