Create an account on the HP Community to personalize your profile and ask a question
09-07-2011 12:25 PM
The HDX 7000 unit we have, of course, does not have any VGA out ports... only DVI. The problem is most of our projectors and monitors have only VGA ports (I didn't buy the unit, I'm just trying to make it work). When I plug a DVI to VGA adapter into port 1 on the back of the HDX unit and boot it up, it does display the Polycom boot screen on the VGA projector/monitor. However, when the HDX unit is fully booted, it displays no home screen. Instead the projector/monitor loses the video signal. If I hook the HDX unit up with a regular DVI cable and no adapter, it will display as it should.
Could there be a setting that I missed that doesn't take affect until the unit has fully booted up? Or, is using a DVI to VGA adapter simply not a viable solution for this particular model? I just find it strange that I have video and then lose it. Any help that can be provided is greatly appreciated. Thank you.
09-07-2011 02:13 PM
Hi, you will need a DVI-I to VGA adapter. Be sure your DVI adapter has the four small pins (2 top 2 bottom) around the large 'spade' lug. These are the 'analog' pins the VGA needs. Also be sure the HDX monitor output setting is set to VGA.
A trick is to use the remote control to select the display type.
Press and hold the "Display" button for about 5 seconds until the output mode is displayed in the LED window on the remote.
Scroll down until you see VGA then hit the right arrow to select.
09-16-2013 02:05 AM
I have 1 mornitor/TV and 1 projector connect to Polycom. I configured in monitor setting with the first monitor is component type and the second monitor is VGA type.
I also can connect to projector with DVI to VGA adapter and show the far site video on monitor 2. But I can not show the video of the far site on both monitor and projector on the same time, just only one of them.
This is request from my boss. Please help if I can show on both TV and Projector for video of far site?
Thanks so much!
09-30-2014 07:02 PM
I have a Polycom HDX7000 which we use for video conferencing and content sharing in our boardroom at work. the problem is that when we run presentations without any live conference the picture quality is ok but once the live conference is started and if content sharing is done then the projecotr screen tends to get very blurry and it shakes making it very difficult to see any font displayed.
Can anyone advise on above as what can be done, is there any configuration in Polycom which we can set to make presentations visible?