cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
wbobo
Level 1
13 2 0 0
Message 1 of 3
758
Flag Post

Solved!

hp laserjet 9050dn

HP Recommended

I have one hp laserjet 9050dn in my office I switch the power on and the printer is warmup and when it initialise the error code 53.07 appear on the screen.

Any help to solve this error code.

 

thanks

 

student  

0 Kudos
1 ACCEPTED SOLUTION

Accepted Solutions
GuruAid-CS
Level 7
681 681 37 110
Message 2 of 3
Flag Post
HP Recommended

Error code 53.07 indicates a problem with printer memory. The DIMM has to be replaced or reseated.

 

Below are the steps to reseated DIMM module:
1. Turn the printer off. Disconnect the power cord and any cables
2. Remove screws from back of the printer and pull the formatter board out of the printer.
3. Remove the DIMM from the package. Hold the DIMM with fingers against the side edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open, or outward.)
4. Firmly press the DIMM straight into the slot. Make sure the locks on each side of the DIMM snap inward into place. (To remove a DIMM, the locks must be released.)
5. Slide the formatter board back into the printer and tighten the two screws.
6. Plug in the power cord and connect all cables. Turn the printer on.
7. If this message persists then memory is faulty you need to contact HP.

View solution in original post

0 Kudos
2 REPLIES 2
GuruAid-CS
Level 7
681 681 37 110
Message 2 of 3
Flag Post
HP Recommended

Error code 53.07 indicates a problem with printer memory. The DIMM has to be replaced or reseated.

 

Below are the steps to reseated DIMM module:
1. Turn the printer off. Disconnect the power cord and any cables
2. Remove screws from back of the printer and pull the formatter board out of the printer.
3. Remove the DIMM from the package. Hold the DIMM with fingers against the side edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open, or outward.)
4. Firmly press the DIMM straight into the slot. Make sure the locks on each side of the DIMM snap inward into place. (To remove a DIMM, the locks must be released.)
5. Slide the formatter board back into the printer and tighten the two screws.
6. Plug in the power cord and connect all cables. Turn the printer on.
7. If this message persists then memory is faulty you need to contact HP.

View solution in original post

0 Kudos
wbobo
Author
Level 1
13 2 0 0
Message 3 of 3
Flag Post
HP Recommended

thanks for helping  I have replace the DIMM and the error 53.07 disappear, it was working again.

 

thanks

 

student.

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation