Question
Reply
 
Highlighted
Honor Student
Posts: 2
Member Since: ‎05-16-2013
Message 1 of 1 (119 Views)

IPSec Tunnel on SmartZero T510 - Help needed

Hello,

Is there any documentation on how to setup the IPSec tunnel on Smart Zero OS, I'm lost on what to put in the source and destination addresses in "General" and in the "Tunnel", where should I put the address of my security gateway ? What is the format of the addresses (can I put a netmask with a / for the destination network) how do I configure source address when it's a DHCP address (%any ?).

 

Any sample of a working configuration would help me a lot.

 

Thanks

 

Patrick

Reply
0
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation