Zbook 17 g3 bottom cover

[wsandifer05]

Can anyone tell me what size torx driver I need to open the bottom access panel?

[GBL84]

Hello wsandifer05,

Welcome to FORUM !!

 If  you are referring to the base enclosure then :

1. On the bottom of the notebook, loosen the eleven captive T8 Torx-head screws that secure the base enclosure to the top cover.
2. Carefully separate the edges of the base enclosure from the top cover.
3. Lift the rear edge of the base enclosure and remove the retention tabs on the front edge of the base enclosure from the cut outs in the top cover.

Please go to this link http://h20464.www2.hp.com/index.html and see the Replacement videos.

Hope this helps, for any further queries reply to the post and feel free to join us again

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

Thank You,

GBL84

I am not an HP Employee

[wsandifer05]

Thanks, T8 was the info I needed.

[GBL84]

You're very Welcome !!

Did my reply resolve your post or question? 

If yes, then share the good news! Let others know this reply was helpful by accepting this solution.
You can also show your appreciation by giving kudos

All the Best !!   Thanks for being a member!

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

Thank You,

GBL84

I am not an HP Employee