• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎02-26-2017 11:49 PM

HP Recommended

I have a project, using a temperature sensor, TMP36 and Arduino. Basically its a bluetooth thermometer. Everything worked fine at breadboard and connected and energized by my notebook. Now I connected it to a 4 x AA recharchable batteries and I started to get wrong temperatures (running on USB, I get 22 degrees, running on batteries, I get 44 degrees).

As formula to get the temperature, I'm using this one:

Temp in °C=Vout(in mV)−50010Temp in °C=Vout(in mV)−50010

My debug info follows:

UPDATE

  1. USB (5v)

voltage read from TMP36 = 147

voltage converted to 5v arduino

(147 * 5.0) / 1024  = 0.71temperature = (0.71 - 0.5) * 100 = 21.78
  1. Battery

4 x reachargable AA = 1.2v (voltimeter says 5.6v) not enough energy to turn it on the BT module, but the board was turned on (power light was on)

  1. Recharged Battery

4 x reachargable AA = 1.2v (voltimeter says 6v.7)

voltage read from TMP36 = 171 voltage converted to 5v (I assume, that the arduino has a voltage regulator to limit the input to 5v, right?)

171 * 5.0 / 1024 = 0.83 
temperature = (0.83 - 0.5) * 100 = 33

my questions are:

  • Is there a way to correct it via software or should I drop the voltage, using a diode/resistor?

  • At the datasheet its written that the input voltage range is from 7v to 23v. Does it means that it has a regulator to 5v internally to regulate my arduino to 5.5v? Does it means as well that I will need more battery to put it to work?

Arduino used is the Iteaduino BT

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.