11-04-2011 10:31 AM
when i tried to recover windows 7 from recovery DVD which i created from the recovery partition , i got the error code: 0xe0ef0003 and the laptob didn't run the windows again, so i can't start it anymore , the model is HP G62-121EE ... please help. cause i think the problem is not a software problem.
This question was solved. View Solution.
11-05-2011 12:10 PM
Test the hard drive then the memory modules, post back the results.
11-07-2011 07:37 AM
Ram test completed , HDD test : the device switch off during the test, it happened twise , first time the short test completed and it switched off at the long test , secnd time , it didn't complete the short test and switched off.
11-07-2011 08:09 AM
I think you have a bad hard drive, it needs to be replaced.
Did you make the HP recovery discs when you got the PC?
If not you will need to order a set, then replace the hard drive and use the recovery set to install the Operating System.
You can order recovery media here if you do not have them
If you have important data on the old hard drive I can show you how to save it once the new hard drive is installed and recovery has been performed, do not throw away the old hard drive
11-07-2011 09:12 AM
It could be other hardware causing the shut down during the test, unfortunately there is no good way to figure out what it is, you may have to send it in for repairs or try another hard drive to see if that cures the problem.
11-07-2011 03:26 PM
11-07-2011 03:31 PM
I have the similar problem, same error code while i tried to recover system from DVD i ve created. I also cannot start Windows 7 anymore. Loptop model pavilion dv6 2114 sa. I performed memory test and hard drive test and they both passed. I think it's the software problem though. What to do? Can you help?
Start a "new post" on this board with all the details.
12-06-2011 06:53 AM
i just bought a new hardrive, a 500gb western digital scorpio blue, after my original hard dive failure, and i did create recovery discs but the recovery gets up to 98-99% then gives me the recovery error. And the the techs that diagnosed my problem put in their hard disk and it worked fine.