cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
ANDYGODWIN
New member
2 1 0 0
Message 1 of 3
713
Flag Post

Printer show error 14.11 , curing residual current circuit breaker (RCCD) trips off.

HP Recommended
HP DESIGNJET L26500

Error message is 14.11. The uring residual current circuit breaker (RCCD) trips off

2 REPLIES 2
davidzuts
Level 13
7,130 7,062 558 1,025
Message 2 of 3
Flag Post
HP Recommended

SE Code: 14.11:00 - Open circuit in the Curing Module
Problem Description:
Power is applied to the Curing module and then the current is measured, if the flow of current is not as
expected, the system error is displayed
Corrective Action:
• Troubleshoot the Curing Assembly  Page 64.
• Check the cable between the PSU and the cable of the Curing Residual Current Circuit Breaker
(RCCD)
• Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again
immediately (or often), this would indicate an error with the Curing Assembly or the RCCD.
• Check to see if there is a blown fuse in the Heater Control Assembly (F1 and F2) page 61.
• Replace the Heater Control Assembly  Page 473.
• Faulty resistor in the Curing Module, replace the heaters in the Curing module  Page 534.

 

See the attached

Was this reply helpful? Yes No
ANDYGODWIN
Author
New member
2 1 0 0
Message 3 of 3
Flag Post
HP Recommended
Thanks, the steps were followed and it yielded good result.
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation