cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
lgreenman
New member
1 0 0 0
Message 1 of 2
529
Flag Post

T790 Plotter stuck on 1% initialize

HP Recommended
Plotter T790

My Plotter T790 is stuck on 1% initialization

Tags (1)
1 REPLY 1
rasheddul
Level 7
634 609 35 85
Message 2 of 2
Flag Post
HP Recommended

Please turn off the printer and remove the formatter board the clean the connector. Again reset it in correct position.

 

Then turn ON the printer and see that here comes any error in the printer display.....if comes please share.

 

You may try also disconnect the all internal cable and connect again and lets see what happend.....

 

 

 

Regards/RAshed

Regards/Rashed
https://www.linkedin.com/in/rasheddul
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation