cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
stansumboy
New member
2 1 0 0
Message 1 of 3
887
Flag Post

error code of 06030800000008. changed print heads as instructed by hp. shows same error on start up

HP Recommended
designjet 1050c plus
Microsoft Windows XP (64-bit)

I replaced printheads as instructed by HP on troubleshooting page

All printheads are showing ok in display

Printer goes back to error code on start up

2 REPLIES 2
EOJTech
Level 4
68 65 9 19
Message 2 of 3
Flag Post
HP Recommended
You may want to perform an Electronics Systems test to try and isolate the the problem. The error code you reference points to the carriage assembly, trailing cable, or electronics module if replacing the printheads did not resolve it.

The procedure is far too lengthy to put in here but it is very well presented in the service manual (or Google the model and error code to find an excerpt). If there is a failure in any of the components mentioned above, the test should find it. Also, heed the advice given in the test - do not replace components that pass the test - you will be wasting your money.

Good luck!
Was this reply helpful? Yes No
stansumboy
Author
New member
2 1 0 0
Message 3 of 3
Flag Post
HP Recommended

thanks for advice and solution..will try, and let you know

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation