cancel
Showing results for 
Search instead for 
Did you mean: 
Chris0151
New member
1 0 0 0
Message 1 of 2
156
Flag Post

Go sprocket not connecting

HP Recommended
Hp sprocket

So I let my friend connect to my printer via the app on his phone and I cannot get my printer to connect back to my phone. He has deleted the app. When ever I try to connect it says make sure the printer is on and in range which it is. 

Plz help

0 Kudos
Tags (1)
1 REPLY 1
A4Apollo
Retired
Retired
17,747 17,730 1,301 2,097
Message 2 of 2
Flag Post
HP Recommended

Hi! @Chris0151, Thank you for visiting the HP Support Community! A great place where you can find solutions for your issues, with help from the community!

 

Please share the image version you are running on the smartphone or tablet to assist you better.

 

Try updating the smartphone to the latest version.

 

Try the steps recommended below.

 

First, unpair and delete the sprocket app from your smartphone and install the sprocket and app and pair the sprocket again to your smartphone.

 

Please share the operating system you are running on your smartphone or PC to assist you better.

 

Try few steps recommended below.

 

1.    Reset the Sprocket unit by placing a push-pin or needle into the small hole on the rear of the unit.  (Reset instructions in the support doc HERE)
2.    Plug in the Sprocket unit with the provided micro-USB cable.  Connect to either a computer USB port or USB wall charger.
3.    Allow the Sprocket unit to charge for 10 minutes.  Note:  A call back may be required in these instances.
4.    Power on the Sprocket unit by pressing/holding the power button for 3 seconds.
5.    A white LED should illuminate on the rear of the unit if power up is successful.
6.    Remind the customer to charge their Sprocket for an additional 60-90 minutes to enable a full battery charge.
 

If the issue still persists uninstall the sprocket app and reinstall the app and try updating the sprocket firmware from the sprocket app and check if it helps.

 

Open Sprocket app go to menu-->Sprocket---> Printers; A blue firmware update link will be present if an update is available.

 

Also, unpair the sprocket from your smartphone and add the printer again and check if it helps.

 

Refer this article to know more information about using sprocket printer.

 

Let me know if this helps!

Have a pleasant day ahead! 🙂

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

A4Apollo
I am an HP Employee

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation