• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Locked

‎06-15-2024 08:55 PM

HP Recommended
Product: HP Z8 G4 dual gold 6140 128Gb
Operating System: Microsoft Windows 10 (64-bit)

hello everyone,

 

Not exactly sure what I did, only remembering ran a few HP driver/firmware updates, after that, the 10Gb NIC only showing 100Mbps speed, windows 10 64.  thought it was the card gone bad, over heating, etc, bought 3rd 10Gb NIC, again, regardless which pci-e slot, it only showing as 100Mbps speed.  

I've cleared CMOS, cleared pwd, set to defualt BIOS, reloading a known good config file, regardless, now all 4 10Gb NIC only showing as 100Mps speed.  

please can someone pointing me to the right direction to correct this? thank you.

Category:
1 REPLY 1

‎06-15-2024 09:29 PM

HP Recommended

@knightcat 

 

Its specs

 

         https://support.hp.com/us-en/document/c05791621

 

Which port do you connect to ? Please check LAN cable first,

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.