HP ProCurve E-MSM320 Access Point doesn't show management UI via https://192.168.1.1

[P1-H1]

I purchased a second hand HP ProCurve E-MSM320 Access Point  and just performed a reset.

Tech data and specs:

HP ProCurve E-MSM320 Access Point
ModelNo: MRLBB-0902

Wireless Protocol802.11a/b/g
Communication Modefull-duplex, half-duplex
Data Transfer Rate54 Mbps
Power Over Ethernet (PoE)PoE

I followed the manual and tried to switch to autonomuous mode:

http://content.etilize.com/Manufacturer-Brochure/1022988180.pdf

POE Switch, connected HP Access point via LAN Cable to POE  Port

Configured Win10 PC to use 192.168.1.2 IP with gateway to 192.168.1.1

After connect and boot I can ping the Win10 PC (192.168.1.2) and the Acess point (192.168.1.1)

However I'm unable to connect to the management UI via https://192.168.1.1

I get the following errors using differnet browsers:

Win10 IE 11:
Use SSL 3.0 enabled

ERROR: DLG_FLAGS_INVALID_CA
DLG_FLAGS_SEC_CERT_CN_INVALID

go on to the webpage (not recommeded)
--> This website uses an insecure connection

EDGE:
Cannot securely connect to this page
This might be because the site uses outdated or unsafe TLS security settings

Chrome:
This site can't provide a secure connection
192.168.1.1. uses an unsupported protocol
ERR_SSL_VERSION_OR_CIPHER_MISMATCH

Any ideas how I can change the access point to autonomuous mode and specify a custom SSID with WAP2 password?

Thanks for your help!

[Paul_Tikkanen]

Hi:

HP split into two companies several years ago.

HP supports PC's, printers, tablets and calculators.

HP Enterprise (HPE) supports servers, switches, routers and storage.

You may want to post your question on the HPE community support forum -- M and MSM Series devices section

M and MSM Series Networking Forum | HPE Blogs, Discussions and Forums Community

[DGroves]

when you get the error prompt in your web browser about insecure connection, it also gives you the option to continue to the insecure site (the procurve in this case),......... which will the show the procurve web login page, enter credentials and the main config page will display

[P1-H1 · Accepted solution]

Sorry, I didn't get this option on any current browser.

I found out here https://www.manualslib.com/manual/1106100/Hp-Msm320.html?page=4#manual that among others Firefox 2 is supported. I downloaded Firefox 2 portable and there I could add the certificate temporarily.