cancel
Showing results for 
Search instead for 
Did you mean: 
xxxrap
New member
1 0 0 0
Message 1 of 2
4,724
Flag Post

LSI Adapter, SAS2 2308 Mustang

HP Recommended
Z440
Microsoft Windows 10 (64-bit)

Dear, I have in my HP workstation Z440 "LSI Adapter, SAS2 2308 Mustang" for SAS hard drives. In the workstarion installed two SAS - 300gb hard drive only - connected in LSI Adapter. No SATA. The operationg system is windows 10 Pro 64bit. Problem is system showing only one Hard drive second SAS Hard drive volume not showing. Please Help me for proper configuring of both Hard drive. 

1 REPLY 1
joselso
Level 4
107 91 5 16
Message 2 of 2
Flag Post
HP Recommended

The Specifications for LSI SAS2308 controller can be accessed at this URL:

https://www.broadcom.com/support/download-search

       Note that this controller should support JBOD hard disks (see https://en.wikipedia.org/wiki/Non-RAID_drive_architectures

    , so you should be able to access each of your SAS hard disks even if you have not configured them as RAID of any kind.

  More data on its use may be obtained at BroadCom Support page:

  https://www.broadcom.com/support

   (possibly requires some kind of subscription).    Also, Information on configuring RAID on LSI 2308 can be found in HP Z440, Z640 and Z840 Workstation Series Maintenance and Service Guide:

http://h10032.www1.hp.com/ctg/Manual/c04823811

     (pages 106,  110  etc.)

 

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation