cancel
Showing results for 
Search instead for 
Did you mean: 
Shikakaaa437
New member
1 0 0 0
Message 1 of 1
242
Flag Post

Problems with connecting via VNC after the update

HP Recommended
HP t430 Thin Client
Linux

Good afternoon, I have HP thin clients in the concept of a "thin" T430 client with the ThinPro 7.1.0 operating system with service pack 6. After upgrading to version SP16, there was a problem with remote management via the VNC client protocol. There is a very large delay in actions, although everything works quickly on the client itself. Reducing the screen resolution on the client to 800x600 fixes the problem. The following values have been reduced in the TigerVNC remote access program: "user compression level: 0 and Allow JPEG compression: 0. These settings do not increase the response speed of the interface. By installing SP6 on the same thin client, the problem disappears. Tell me where to look to solve this problem, thank you.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation