Windows 10 Pro not showing my other HDDs.

[BSDas]

Hi,

After a fresh Windows 10 Pro installation my other HDDs are not showing.

231GB LSI Logical Volume SCSI Disk Device (SAS(Serial Attached SCSI) ) (Windows 10) Raid 1
1863GB Western Digital WDC WD20EFRX-68EUZN0 ATA Device (SATA ) (only this drive showing)

In BIOS(latest updated few months back) all the drive showing accordingly.

I have installed all the drivers from hp for HP z820 workstation.

Any help would be appreciated.

Thanks.

[DGroves]

if the 231GB LSI Logical Volume drive(s) are connected to the ports along the bottom of the motherboard, check in device manager if the LSI controller is showing up and if so does it have a "!" or red "X" next to it

if no LSI controller shown in device manager, go into bios and enable the LSI controller

note that there are two sections where the LSI shows up one is the LSI device (always leave enabled)

the other is the LSI BOOT ROM, which can be disabled if you are not booting from the LSI ports (windows will still see controller)

[BSDas · Accepted solution]

Hi,

I already did it with the help of forum. 

But when i used Intel Rapid Storage Technology Enterprise V.4.3.0.1198, all the drives now showing again.

I appreciate your suggestions.

Hence my issue is resolved.