Guidelines
We are proud to announce new Poly Studio Series video bars and remote room control with Poly Connect. Read more about the solutions!
Locked

‎03-19-2013 03:07 PM

HP Recommended

Hi,

 

I'm looking for some advice on how to configure our system. We have recently installed Polycom hardware (DMA 7000, RPRM and VBP's), however another region bought a Cisco setup. All our endpoints are registered to our DMA while theres are registered to there Cisco TMS (basically Cisco's version of the DMA) - there is no intergration, no global address book.

 

I'm told there is a way of 'bridging' the two together so they share one address book, is this possible? If so how is it done?

 

I'm reading about a 'supercluster', however from what I've read that is only for Polycom DMA's and there is a requirement that they all run the same OS etc as they share the config....

 

Is anyone able to adise on how to configure this?

 

Many thanks

1 REPLY 1

‎03-19-2013 11:37 PM

HP Recommended

Hi there...

maybe you could take a look here.

Was this reply helpful? Yes No
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.