• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We are proud to announce new Poly Studio Series video bars and remote room control with Poly Connect. Read more about the solutions!
Locked

‎09-27-2013 11:08 AM

HP Recommended

I created the SIP trunk between Diguim switchvox and DMA. The SIP trunk is UP. The call from IP phone registered to digium to VMR on the RMX registered to DMA is ok and the phone able to join the conference.

 

RMX prefix 72, SIP trunk prefix 77

 

when The phone dials 77721001 it connects to the RMX normally.

 

When trying dial out the IP phone (772009) from the RMX the call failed.  

 

Attached the setup drawing.

 

any advise? do I missing anything?

1 REPLY 1

‎10-02-2013 03:04 PM

HP Recommended

Hi,

 

So it looks like the DMA has a dial rule for the SIP trunk to the Diguim switchvox. I would make sure the IP address of the Diguim switchvox is included in a subnet configured in the site topology of a site. If you don't, you run the risk of the DMA trying to route the call through a firewall or some other SBC.

 

S.

Was this reply helpful? Yes No
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.