-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -

Create an account on the HP Community to personalize your profile and ask a question

11-01-2013 02:18 PM
Hello Everyone,
I have a doubt about integration. I have an MGC -25, five VSX 7000 endpoints and two HDX 7000 endopoints. My question is, it can be possible integrate all polycom videoconferencing network to Cisco Call manager?
HDX software version 3.0.5-22695
VSX software version 9.0.1
Cisco call manager software version 9.1.1.20000-5
It is possible integrate the MGC, VSX and HDX to Cisco call manager? if is so possible, What i need to do this?
Solved! Go to Solution.

11-26-2013 07:14 PM
Actually it works though the road to the retarded solution is nowhere to be found on any manual, as it is typical for both Cisco and Polycom 🙂
1. Create a room in MGC and the room number is the critical thing: that number will latter be referenced in the CCM dialing pattern
2. Create a dial-peer in any router:
dial-peer voice 125 voip
tone ringback alert-no-PI
preference 1
destination-pattern 3644
progress_ind setup enable 3
progress_ind alert enable 8
voice-class codec 1
session target ipv4:192.168.248.32
dtmf-relay h245-alphanumeric
no vad
That's it; and yes my room number is 3644 and the IP span of the MGC-25 is 192.168.248.32
Of course in my case 3644 is a valid DID pushed to the SAME router via it's PRI interface so that outside people can also join the conference just as in-house folk. If you put a password on your room then IVR will ask the caller for the password - pretty respectible out of the box functionality.
~B
