• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about printers, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
Locked

‎01-08-2024 02:33 AM

HP Recommended
Product: HP DesignJet Z6dr 44-in PostScript Printer with V-Trimmer
Operating System: Microsoft Windows 10 (64-bit)

Hello community!

We have a Designjet Z6 and print CAD plans with Autodesk LT. The printer cuts the horizontal empty area but not the vertical. The Printer seems not to realise the vertical empty area and cuts along the papersize. Does someone have or had the same problem too.

Category:
2 REPLIES 2

‎01-08-2024 11:26 AM

HP Recommended

Do you have the vertical cutters enabled in the printer setup menus? They can be disabled. You may also need to perform a cutter calibration to ensure they are working properly. The user guide a support.hp.com should provide the guidance you need.

If you find the information provided useful or solves your problems, help other users find the solution easier by marking my post as an accepted solution. Clicking "yes" on "was this reply helpful" also increases the chances that this solution will help others.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.



Was this reply helpful? Yes No

‎01-10-2024 12:40 AM

HP Recommended

The vertical cutters are on and works. But they are cutting not the empty space of the cad drawing. We use the PS driver and there is the problem.

I tested the PCL3 V4 driver and there it seems to work so far.

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.