cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
231Graphik
New member
3 1 0 1
Message 1 of 2
232
Flag Post

Double Sided Printing Alignment

HP Recommended
Latex 360

I am trying to double side print on HP 360 Latex and the second side prints about 1 1/8" higher than the front side.  I go through the prompts on the screen to line it up, it tells me on the display it found the line but is then off.  Same outcome on 2 tries.

 

Thank you!

1 REPLY 1
skuks
Level 5
249 239 13 34
Message 2 of 2
Flag Post
HP Recommended

Have you tried all this instructions:

https://support.hp.com/bg-en/document/c04312467

If loaded substrate skew is set to minimum and line you draw is not at the correct place, check carriage line sensor for dried ink..

And for more info and advises - go to

 https://hplatexknowledgecenter.com/

Check search bar an type double sided printing 🙂 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation