-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
-
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
-

Create an account on the HP Community to personalize your profile and ask a question
02-07-2018 01:02 PM
Can't get rid of the 79.04 code. Have isolated the plotter and confirmed latest firmware.
Display reads:
System Error
Asertion : failed
task: interrupt
file: carmotor.c
line: 2364
Greatfull for any help.
Solved! Go to Solution.
Accepted Solutions
02-07-2018 02:57 PM
Hi
the 79 error is quite generic
Its hard to track down BUT
I have found the most common cause to be a faulty printhead.
If you have a spare set replace them
It only be one which as failed -so you can chase down which one it is
The next cause is the Electronics module. These are available on ebay. It is about 1 hours work to swap it out. Needs only simple tools
Good luck
02-07-2018 02:57 PM
Hi
the 79 error is quite generic
Its hard to track down BUT
I have found the most common cause to be a faulty printhead.
If you have a spare set replace them
It only be one which as failed -so you can chase down which one it is
The next cause is the Electronics module. These are available on ebay. It is about 1 hours work to swap it out. Needs only simple tools
Good luck
Didn't find what you were looking for? Ask the community