Guidelines
We have new content about printers, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
Locked

‎12-13-2023 08:03 PM

HP Recommended
Product: HP DesignJet T2300 PostScript Multifunction Printer
Operating System: Microsoft Windows 10 (64-bit)

 Was stuck at 94% but then gave message saying unable to contact firmware server. Now startup fails and error message reads 21.2:13 Restart printer. Contact HP if problem persists. Well, the problem does persist. I am stuck. I suspect this is a failed hard drive or firmware issue. 

Category:
1 REPLY 1

‎12-21-2023 03:01 AM

HP Recommended

That is a service station error...

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.