• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
HP Recommended
Latex 360

Error code 23:10 HP Latex 360, this code is not in my service manual. Further info ink pump.

1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

the following is from the L25500 Service Manual. I would imagine it would be simialr on the L360.

 

SE Code: 23:10 - Problem with pressurization in the APS
Problem Description:
The APS has received a request to depressurize, but the system does not depressurize in under a specific
time (120 seconds).
Corrective Action:
• Check that the relief valve cable is not damaged and is correctly connected to the PrintMech PCA.
• Check the continuity in the cable of the relief valve.
• Try tapping the relief valve of the APS with a screw driver to release the mechanism.
• Check the air tubes connected to the relief valve are not bent or twisted and that air can flow in the
tubes.
• To check if the issue has been solved perform the APS service test
• If the test fails replace the APS 
• Replace the PrintMech PCA 
• Replace the Sausalito PCI PCA 

 

Good Luck

Roy K

View solution in original post

1 REPLY 1
HP Recommended

the following is from the L25500 Service Manual. I would imagine it would be simialr on the L360.

 

SE Code: 23:10 - Problem with pressurization in the APS
Problem Description:
The APS has received a request to depressurize, but the system does not depressurize in under a specific
time (120 seconds).
Corrective Action:
• Check that the relief valve cable is not damaged and is correctly connected to the PrintMech PCA.
• Check the continuity in the cable of the relief valve.
• Try tapping the relief valve of the APS with a screw driver to release the mechanism.
• Check the air tubes connected to the relief valve are not bent or twisted and that air can flow in the
tubes.
• To check if the issue has been solved perform the APS service test
• If the test fails replace the APS 
• Replace the PrintMech PCA 
• Replace the Sausalito PCI PCA 

 

Good Luck

Roy K

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.