cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
KUMAR_JI
New member
1 0 0 0
Message 1 of 6
2,022
Flag Post

HP DESIGNJET T2530 SHOWS ERROR 63:20, DOES NOT TAKE COMMAND AFTER 2-3 PRINTS

HP Recommended
DESIGNJET T2530
Microsoft Windows 7 (64-bit)

we are using hp designjet t2530 in out office and it has started showing error 63:20 recently. sometimes it takes 2-3 commands and then stops printing or sometimes it hangs up. can you please tell me what may have caused the problem and how to solve it.

5 REPLIES 5
Jorge70
Level 4
101 101 6 13
Message 2 of 6
Flag Post
HP Recommended
Hello.
You do up grade the firmware to last version.
Was this reply helpful? Yes No
Jorge70
Level 4
101 101 6 13
Message 3 of 6
Flag Post
HP Recommended
Hello.
You do up grade the firmware to last version.
Before replace the network cable.
I hope helps.
Was this reply helpful? Yes No
davidzuts
Level 13
7,130 7,062 558 1,025
Message 4 of 6
Flag Post
HP Recommended

Problem Description: Input/Output problem through the network interface of the Formatter
Corrective action: Try the following:
1. Switch the power off from the back of the product and disconnect the power cord.
Reconnect the power cord and power on the product.
2. Check that the Network cable is correctly connected to the Formatter.
3. Check that the product has the latest firmware version. If not, update the firmware to the
latest version.
4. Replace the Formatter. See Formatter on page 381.
NOTE: For Revision B printers the Formatter and Hard Disk are replaced as a single part.

Was this reply helpful? Yes No
Mark91975
New member
1 1 0 0
Message 5 of 6
Flag Post
HP Recommended

How can I tell if Rev A or Rev B?

Was this reply helpful? Yes No
kevin-t
Retired
Retired
20,511 15,611 325 972
Message 6 of 6
Flag Post
HP Recommended

Hello,

Thank you for posting in this thread. Unfortunately based on when the last response was made, I have closed this thread to help keep comments current and up to date. We recommend starting a new thread for your issue by clicking here.
To be more helpful with your post, you can add key information if you desire: 
1. Product Name and Number (please do not post Serial Number)
• Example: HP Pavilion DV2-1209AX or HP Deskjet 3000 Printer CH393A
2. Operating System installed (if applicable)
• Example: Windows XP, Windows Vista 32-bit, Windows 7 64-bit
3. Error message (if any)
• Example: ""Low disk space"" error in Windows
4. Any changes made to your system before the issue occurred
• Examples: Upgrading your Operating System or installing a new software; or installing new hardware like a printer, modem, or router.
If you have any other questions about posting in the community, please feel free to send me a private message!

Thank you


I work on behalf of HP
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation