cancel
Showing results for 
Search instead for 
Did you mean: 
jankertw
Level 1
5 3 0 1
Message 1 of 5
714
Flag Post

Solved!

HP Latex 360 noise

HP Recommended
latex 360
Microsoft Windows 10 (64-bit)

My printer(Latex360) has some noise
Image quality printing and printing work have noise

First of all, I think it is caused by RIP, but the image quality prints the same problem.

Not paper pollution ,  it is a regular ink drop

some one can help me ?

printing workprinting workImage quality printingImage quality printing

 

1 ACCEPTED SOLUTION

Accepted Solutions
skuks
Level 5
243 241 13 31
Message 2 of 5
Flag Post
HP Recommended

This happens when you have faulty printhead (PH)  with many missing nozzles or spaying all over but not in straight direction, check LM/LC and optimizer's PH. If all is good - clean the printheads and  make an alignment.

Also happens when humidity is high (when raining) and substrate surface becomes moistened...use another substrate and check results...

And some other thing - when printing - use color bars (make them about 1cm wide) on both sides of the printed image and push the lights. When printing take a look which printhead is spraying not printing straight line....

Could you take pictures of Printed test plot of all PH's (separately for each Printhead) and post it here?

View solution in original post

4 REPLIES 4
skuks
Level 5
243 241 13 31
Message 2 of 5
Flag Post
HP Recommended

This happens when you have faulty printhead (PH)  with many missing nozzles or spaying all over but not in straight direction, check LM/LC and optimizer's PH. If all is good - clean the printheads and  make an alignment.

Also happens when humidity is high (when raining) and substrate surface becomes moistened...use another substrate and check results...

And some other thing - when printing - use color bars (make them about 1cm wide) on both sides of the printed image and push the lights. When printing take a look which printhead is spraying not printing straight line....

Could you take pictures of Printed test plot of all PH's (separately for each Printhead) and post it here?

View solution in original post

jankertw
Author
Level 1
5 3 0 1
Message 3 of 5
Flag Post
HP Recommended

An hour ago, i update firmware NEXUS_01_16_00.8 

Reset the machine, and clean the printheads and  make an alignment.

it looks good now, I will observe again,

thank you Skuks 🙂

0 Kudos
jankertw
Author
Level 1
5 3 0 1
Message 4 of 5
Flag Post
HP Recommended

An hour ago, i update firmware NEXUS_01_16_00.8,

reset the machine,  clean the printheads and  make an alignment

It looks good right now, I will pay attention to it again.

thank you Skuks

skuks
Level 5
243 241 13 31
Message 5 of 5
Flag Post
HP Recommended

I'm glad I could help at this one 🙂

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation