cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
myrecs
New member
1 0 0 0
Message 1 of 2
374
Flag Post

Latex 335 - material crumpling

HP Recommended
Latex 335
Microsoft Windows 10 (64-bit)

While printing long job material becomes crumpled under the rollers. Material - syntetic canvas (230-260 g/m2), 1.52 m width. Not at the start but may be at the roll half. And somewhere at the width center. Bumps appear on the material and then printing head begins th scratch it.  Only stopping print and lifting rollers helps to align material(.  Changing vacuum, temperature and so on doesn't affect anything. And this problem also exists with Latex 360. Is this HP's defect?

20181213_182909.jpg20181213_183052.jpg

1 REPLY 1
1111SLV__
Level 2
Level 2
20 19 1 1
Message 2 of 2
Flag Post
HP Recommended

I belive your question was solve on the HP Latex Knowledge Center https://hplatexknowledgecenter.com/forum/default/latex-335-material-crumpling-2 if you have further questions, please do no hesitate to post again in the HP Latex Knowledge Center.

Regards

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation