cancel
Showing results for 
Search instead for 
Did you mean: 
PS-FL
New member
2 1 0 0
Message 1 of 4
156
Flag Post

T1300 power button

HP Recommended
Designjet T1300

I have a problem with my Designjet T1300. It doesn't powers up from the POWER button, but lights up when I switch the button on the power supply. The button's light is on, the switch itself is OK ( tested ), but doesn't react when I want to power down the printer. I have to switch off from the power supply, and booting after that is very slow, which is kind of annoying. If You have and solution how to make it work again.  I can't find electrical diagrams and it seems you have to replace the whole panel.  Very annoying.  What is it "usually" and what is the easy and cheap solution (I can even put in another toggle switch if that will fix it).
Thanks,
Paul

3 REPLIES 3
rubensanchez01
Level 1
7 6 0 0
Message 2 of 4
Flag Post
HP Recommended

try to       replace the 3 volt battery on formatter board & will boot up much quicker....

Reply
0 Kudos
PS-FL
Author
New member
2 1 0 0
Message 3 of 4
Flag Post
HP Recommended

Thanks but speed is not the issue.  The button not working (to turn on or off) is the issue.  It does light up when on, but does not work.

Reply
0 Kudos
rubensanchez01
Level 1
7 6 0 0
Message 4 of 4
Flag Post
HP Recommended

turn on & off from the back......if formatte battery bad & printer will check all & caused horribily slow.... less $1......

Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation