• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines

Featured blog article:

Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
HP Recommended
Designjet T2530 MFP
Microsoft Windows 11

Hi.

I am troubleshooting a Designjet T2530 mfp.

 

It print misaligned vertical lines. I have clean the encoder strip, clean and oil the cariage rod, align the printhead few times, did a Paper advance alignment and check the service station in case the cutter bump in to it.

 

Also I clean the line sensor (right side of the cariage).

 

Still the vertical lines are misaligned.

 

I just order: scan axis motor, encoder strip and belt that I will instatomorrow.

 

Any advise?

8 REPLIES 8
HP Recommended

If you increase print quality, is it still misaligned? Are internal print reports misaligned?


My profile on LinkedIn

HP Recommended

Hi. Yes I encrease the quality, no change. It does it with the internal prints.

 

20261105_084442.jpg

HP Recommended

Hi.

 

I have replaced the: scan axis motor, carriage belt & encoder strip. It have inprove but still not at 100%.

 

Do you have any clues about what else could improve the verticals lines?

 

20261106_101852.jpg

HP Recommended

Did you clean the encoder DISC?  Left side of machine below the spitoon.  I had a similar problem and it turned out to be a smudge of grease on the disc was the cause.

I don't work for HP....I just repair their printers.
HP Recommended

Hi. Thanks for the help.

 

Is it the encoder sensor that is with the Motor Media Advance Transmission?

 

DJ T2530-encoder disk.bmp

 

HP Recommended

The spitoon on this model DJ T2530MFP is included in the service station.Do you mean under the service station?

HP Recommended

Not the SENSOR but the DISC.  It's the round plastic disc that is black and has clear spaces.  I would try cleaning that (it comes off pretty easy and just sticks back on.  Don't worry about alignment; it will self-align when the printer boots)  It's right above the furthest right blue circle shown on your picture.  Sometimes it will have debris from paper dust or grease from the factory.

I don't work for HP....I just repair their printers.
HP Recommended

Hi. Thanks.

 

I will try that when I get back to my customer site.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.
-->