Z3100 starts with FSCK but errors out after an hour or so

iprintsettle · ‎12-08-2023

I am sure this is not a new question, but I new problem for me!

My designjet Z3100 starts OK with a FSCK and works well for around an hour and then errors out with a out with a 0.1.10 error.

It has had a new factor suppied Print Mech PCA board fitted and worked fine for a while, but now this? I have tried changing the battery in the formatter but without any joy.

I can't get my head around why it can start OK? Logic tells me that the PCA board is OK otherwise it would not work at all,

Can anyone please help?

Repairatrooper · ‎12-08-2023

That it starts with a drive check suggests that the harddrive might be the problem.

If you find the information provided useful or solves your problems, help other users find the solution easier by marking my post as an accepted solution. Clicking "yes" on "was this reply helpful" also increases the chances that this solution will help others.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.

iprintsettle · ‎12-08-2023

Thanks for your reply. Is it as easy as ordering a new hard drive?

Create an account on the HP Community to personalize your profile and ask a question