-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Printers
- DesignJet, Large Format Printers and Digital Press
- how to replace nozzle

Create an account on the HP Community to personalize your profile and ask a question
04-25-2021 04:47 AM - edited 04-25-2021 04:54 AM
this z3200 44" leaked lots of magnta inks & I could never pass the printhead alignment.
removed the carriage box cover, also removed 2 tiny clips, also the leak nozzles...
I bought new nozzles & just want to ask someone on this board might did before
& have experience.
I was thinking to use heat to warm up inktube & insert the new 1.
or use new tiny soft plastic tube connect nozzle & inktube, then super glue both ends.
if someone out there know & please advise.
see photos
04-26-2021 05:57 AM
I've used a hair dryer to heat up the tubes and reattach them in the past. Clean everything up very well and set the heat on medium and take your time with it. Those parts can be fragile.