I am trying to get a thin client up and running. I originally tried to use an image from older T610s which caused some bad display issues. I was finally able to run a factory reset on the unit to try and start fresh, but upon reboot I was greeted with a jumped pixelated screen. After this, I had to forcefully reboot, and now the error I'm receiving is;
Kernel panic - not syncing: Attempted to kill init! exitcode=0x00000007
Pid: 1, comm: init Not tainted 3.8.13-hp #4
At this point it just hangs until it's physically turned off. I understand I likely made a mistake trying to use the T610 image and likely need to set this unit up from scratch. I'm just trying to get the thin client back to that stage.