Need a Factory Version of BIOS Firmware

[rapcorreia]

Hi, there!
I bought an HP Pavilion h8-1010pt in 2011 and I need help to solve a problem.
The BIOS is corrupted and the PC doesn't boot or enter the BIOS.
All the processes for resetting the CMOS (changing the battery, jumper) have been carried out, but the problem is exactly in the BIOS.
I need to "flash" the BIOS with the Firmware that was installed at the factory, but for that I need the respective Firmware. Only the latest BIOS version is available on the hp website.
I have the ability to perform the "flash", but I am missing that version of the BIOS and for that I would like to know if any of you know what version is and where I can download it.

This is the motherboard type: IPISB-ch2 623913-001 Rev 0B

Thanks a lot!...

[Riddle_Decipher]

@rapcorreia Let's perform a power reset as per HP standards:

Ensure your device is OFF.

Unplug all the external devices (If any).

Disconnect the power from the computer

Press and hold the power button for about 30 seconds.

Connect the power supply

Press the power button to turn on your device and check if the issue persists.

If the issue persists, after the above steps, try the below:

To recover an earlier version of the BIOS on your computer:

1. Turn off the computer.

2. With the computer off, press and hold the Windows key and the B key at the same time.

3. Still pressing those keys, press and hold the Power button on the computer for 2 to 3 seconds, and then release the Power button but continue to hold the Windows and B keys until the BIOS update screen displays or you hear a beeping sound (usually 8 beeps).

   NOTE: 

   If the key presses do not work, press and release the Power button, and then immediately, press the Windows and B keys at the same time, repeatedly, until the computer beeps or opens the BIOS update screen.

   The power LED light remains on, and the screen remains blank for about 40 seconds before anything displays on the monitor. You might also hear beeping sounds. Eventually, an HP BIOS Update screen displays and the BIOS update begins automatically.

   

   • If the HP BIOS Update screen displays proceed to the next step.

   • If the HP BIOS Update screen does not display, do one of the following depending on the condition:

   • Computer starts into Windows: The computer starts into Windows if the power button and keys are released too soon. Repeat the previous steps, holding the power button down for 2 or 3 seconds.

   • Power LED light turns off: The computer turns off if the power button is pressed and held down too long. Repeat the previous steps, holding the power button down for between 2 and 3 seconds.

   • After repeated attempts, the HP BIOS Update screen does not open: Your computer does not support this function or it has a hardware problem that is preventing the tool from opening.

FOR DETAILS & FURTHER INSTRUCTIONS, USE THIS LINK: CLICK HERE & SKIP TO STEP 4 ONWARD

(By the end of this article all the issues should be resolved)

P.S: Welcome to HP Community 😉

Let me know how that pans out,

If you feel I was helpful, simply click on Accept as Solution to help the community grow,

That said, I will have someone follow-up on this to ensure you've been helped,

Just in case you don't get back to us, 

have a good day, ahead.