Question about PC

[BrandonP]

I swapped the pentium E2200 processor with a pentium D 925 processor.  The PC was beeping when I turned it on with the 925 processor so I shut it off and put the E2200 processor back in it.  It's no longer beeping however I don't know if it's funtionally normally since I have no video now.  I have a dell E2014 monitor connected to a video card.  Not sure of the video card model.

[erico]

You put a Pressler processor in an incompatible motherboard.  

You might have damaged your motherboard.

The following processors are compatible with your motherboard.

• Intel Core 2 Quad (Y) Q9xxxx
• Intel Core 2 Duo (W) E8xxx
• Intel Core 2 Quad (K) up to Q6600
• Core 2 Duo E6x00 (C) up to E6700
• Core 2 Duo E4x00 (C) up to E4400

[BrandonP]

If it had damaged the motherboard, wouldn't it still beep when I turn it on?  It does not beep now that I put the E2200 processor back in it.

[erico · Accepted solution]

@BrandonP

Did you connect the display to the I/O plate at the back of the PC or to a video card? 

Your PC, according to the specs was not delivered with a video card.

I suggest removing the vidoe card and trying the output at the rear of the motherboard.

@BrandonP

That is just putting it back into its base configuration to verify that it still works.

[BrandonP]

Yes, I Installed a Radeon 5450 video card so I could connect my DVI monitor.

[erico]

See my previous post. I edited it.

[BrandonP]

It looks like something is wrong with the motherboard.  I put in a new video card but still get no video.  I have another desktop to use with the new video card.  Thank you @erico for your assistance.