-
×InformationNeed Windows 11 help?Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
-
-
×InformationNeed Windows 11 help?Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
-
- HP Community
- >
- Desktops
- >
- Desktop Boot and Lockup
- >
- RP5800 Shuts down
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page

Create an account on the HP Community to personalize your profile and ask a question

RP5800 Shuts down
03-27-2021 07:52 PM

I have been trying to get a RP5800 up and running. Had it given to me and i figured it would be good to use with my 3D printing work. My problem is after around 30 minutes it just shuts off. No warning or any thing it just shuts off. I am running windows 10 64bit on it. I have done 2 fresh windows install on the hard drive and now one on the SSD i have in it. To rule out that it was maybe windows i tried a live linux distro and it still dies. Odd thing about it is when it shuts off one of the leds on the front that show the status of the network flashes until i push the power button. I have went through the BIOS, and updated the BIOS. To rule out other problems i unhooked the dvd drive, unhooked the front panel power switch, unhooked the network cable and cleaned it all out. Could it be a power supply issue or some thing else
Thanks, Dan
My specs are:
Windows 10 64bit
Core i3-2120
250G SSD
500G Hard drive
4G memory
Radeon HD 6350

Didn't find what you were looking for? Ask the community