cancel
Showing results for 
Search instead for 
Did you mean: 
jwood_mls
Level 1
11 5 0 0
Message 1 of 2
122
Flag Post

Set initial password with BCU on Prodesk 400 G5

HP Recommended
ProDesk 400 G5
Microsoft Windows 10 (64-bit)

I have some new ProDesk 400 G5's that I was working on imaging.  As part of that process, I have in the past run the BCU, setting the password & applying config.

 

I can't get it to work on these new systems.  When I run the BCU with the npwdfile option, it says that the password is set, but that the one I'm giving is invalid.  However, if I manually go into the setup, there is no password set.  Any suggestions at all?

1 REPLY 1
jwood_mls
Author
Level 1
11 5 0 0
Message 2 of 2
Flag Post
HP Recommended

Nevermind - finally found documentation that mentions that this error can also be caused by not meeting the password requirements, and that's exactly what the issue was.

 

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation