Do I need to change the back plate of cpu cooler when changing the cooler

[Wess2008]

I have victus 15l tg02 and I want to change cpu cooler because the temps are little high 83c° under full load and I want to know if need to change the cpu back plate

The new cooler that I will use Is master cooler i70c lga1200

[Raj_05 · Accepted solution]

Hi @Wess2008,

Welcome to HP Support Community.

Thank you for posting your query, I will be glad to help you.

When changing the CPU cooler on your Victus 15L, whether you need to change the backplate depends on the compatibility of the new cooler with your motherboard.

For the Master Cooler i70C, which is designed for LGA1200 sockets, here are the steps to determine if you need to change the backplate.

• Check Compatibility: Verify if the new cooler includes a backplate or if it uses the existing one. Most coolers that are compatible with LGA1200 will come with a mounting kit that either works with the existing backplate or includes a new one.
• Inspect Existing Backplate: Look at the current backplate on your motherboard. If the Master Cooler i70C comes with its own backplate and mounting hardware, you'll typically need to remove the old backplate and install the new one provided.
• Mounting Kit: Review the installation instructions for the Master Cooler i70C. These instructions will clarify whether you need to use the existing backplate or replace it. If the cooler includes a backplate, follow the manufacturer's instructions for installation.
• Thermal Paste: Don’t forget to clean off the old thermal paste from the CPU and apply a new layer before installing the new cooler.

I hope this helps.

Take care and have a good day.

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

Alden4

HP Support 

[Wess2008]

Thank you very much can I ask you one more question how is my cpu fan has to because I read on the net that if you tight it too much you can damage ypu cpu or motherboard 

And thank you again

[Raj_05]

Hi @Wess2008,

Thank you for your response, 

Yes, overtightening your CPU fan or cooler can indeed damage your CPU or motherboard. Here's a guideline on how to ensure it's properly secured without causing damage.

• Tighten Evenly: When securing the CPU cooler, tighten the screws or brackets in a cross pattern. This means tightening the screws diagonally opposite each other a little at a time, rather than tightening one screw all the way before moving to the next. This ensures even pressure on the CPU.
• Use Appropriate Force: Most coolers are designed to be tightened to a specific level of torque. You don’t need to use excessive force; usually, snugging the screws until they are firmly in place is sufficient. If you have a cooler that specifies a torque value, use a torque screwdriver to avoid over-tightening.
• Manufacturer Instructions: Always follow the HP installation instructions. This will provide guidance on the proper installation procedure and how tight the cooler should be.
• Check for Flex: After installation, check if the motherboard is flexing. If it is, you might have tightened the cooler too much. The board should remain relatively flat with minimal bending.
• Inspect the Cooler Contact: Ensure that the cooler is making proper contact with the CPU. If it's not seated correctly, it might indicate that the screws are either too loose or overtightened.

By carefully following these steps, you can avoid damaging your CPU or motherboard while ensuring your CPU cooler is properly installed. 

Take care and have a good day. 

Alden4

HP Support