cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
oldsparky
New member
1 0 0 0
Message 1 of 3
142
Flag Post

memory upgrade for hp 6200 pro sff

HP Recommended
hp 6200 pro sff
Linux

Can I use 8 Gig ddr3 memory modules in hp 6200 pro sff? I would like to buy 2 8 gig modules for this machine

2 REPLIES 2
banhien
Level 19
Level 19
96,919 63,556 12,563 20,913
Message 2 of 3
Flag Post
HP Recommended

@oldsparky 

 

Its specs

 

             https://support.hp.com/au-en/document/c02779493

 

It supports 16GB 1333 MHz DDR3 SDRAM max (4 x 4GB) you can't install 8GB to one slot. You have to buy four 4GB modules.

 

Regards,

 

        

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




>
Was this reply helpful? Yes No
Paul_Tikkanen
Level 21
Level 21
138,187 90,267 21,341 28,093
Message 3 of 3
Flag Post
HP Recommended

Hi, @oldsparky 

 

You can install up to 4 x 8 GB of memory in your PC for a total of 32 GB.

 

See the HP quickspecs link below, page 7.

 

HP Compaq 6200 Pro Series (highspeedbackbone.net)

 

System Memory Support


The HP Compaq 6200 Elite Series supports the 2nd generation Intel® Core™ processor family. Based on a new PC microarchitecture, the processor is designed for a two-chip platform consisting of a processor and Platform Controller Hub (PCH). Unlike previous generations, the processor includes an integrated memory controller (IMC). The IMC supports DDR3 protocols with two independent, 64-bit wide channels each accessing one or two DIMMs.


Two channels of non-ECC unbuffered DDR3 memory with a maximum of two UDIMMs per channel
Single-channel and dual-channel memory organization modes
Data burst length of eight for all memory organization modes
DDR3 memory data transfer rates of 1066 MT/s (PC3-8500) and 1333 MT/s (PC3-10600)
64-bit wide channels
DDR3 I/O voltage of 1.5V
Maximum memory bandwidth of 10.6 GB/s in single-channel mode or 21 GB/s in dual-channel mode assuming DDR3 1333
MT/s (PC3-10600)
The largest memory capacity possible is 32GB using four (4) 8GB DIMMs

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation