cancel
Showing results for 
Search instead for 
Did you mean: 
Golum
New member
2 0 0 0
Message 1 of 2
3,722
Flag Post

Kernel Security Check Failure - windows 10 do not start

HP Recommended
HP all in one 27
Microsoft Windows 10 (64-bit)

My computer does not start. It gets stuck in a blue screen with an error message saying Kernel Security Check Failure. 

I have tried reset this PC etc with no success. I think I need to reinstall windows 10 but my computer did not came with a CD or something for that. Any help is highly appreciated. 

1 REPLY 1
KrazyToad
HP Support Agent
HP Support Agent
22,744 22,731 1,364 1,380
Message 2 of 2
Flag Post
HP Recommended

@Golum

 

Welcome to HP Community

 

I have gone through your Post and would like to help

 

First run a System Test to confirm the hardware functionality

 

- Shut down the Notebook completely
- Turn it back on, then tap the Esc key repeatedly until the Startup menu screen is displayed.
- Press F2 to select System Diagnostics.
- Click System Tests

 

If all the tests pass, I suggest you perform a System Recovery

 

- Turn off the computer.Disconnect all connected devices and cables such as Personal Media Drives, USB drives, printers, and faxes.
- Turn on the computer and repeatedly press the F11 key about once every second until the Choose an option screen is displayed, and then continue.
- On the Choose an Option screen, click Troubleshoot.
- On the Troubleshoot screen, click Recovery Manager.
- Under Help, click System Recovery.
- When Recovery Manager prompts you to back up your files, select a backup option:
- The Welcome to HP Recovery Manager screen is displayed. Read the on-screen information, and then disconnect any connected devices and cables, such as Personal Media Drives, USB drives, printers, and faxes.
- Remove media from internal drives, and remove any recently added internal hardware.
- Click Next to continue.
- When recovery preparation is complete, click Continue to proceed to the installation phase of the recovery process. The computer restarts several times during the recovery. This is normal. Do not close, shut down, or disconnect the computer while HP Recovery runs.
- Recovery Manager reformats the Windows partition and reinstalls the original software.
- After the system recovery is complete, click Finish to restart the computer. Complete the setup screens and wait until the computer finishes the setup.
- Once the setup is complete, turn off the computer, reconnect all devices and cables, and then turn on the computer.
- Before using the computer, update and protect your computer by reinstalling any virus and security software that was installed before the system recovery.
- Reinstall any software programs that were added after purchasing the computer, as well as any files that were backed up.

 

If you are unable to access the System Recovery, you will need the Recovery media

 

The HP Cloud Recovery Tool allows you to download recovery software to a USB drive. You can use the downloaded recovery image file inorder to install Windows operating system. Click here: https://support.hp.com/in-en/document/c06162205 to Use the HP Cloud Recovery Tool (Windows 10, 7)

 

Click here: https://support.hp.com/in-en/document/c04758961#AbT3 to perform a System Recovery (Windows 10)

 

Thank you

 

 

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.
 

KrazyToad
I Am An HP Employee

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation