cancel
Showing results for 
Search instead for 
Did you mean: 
bmelnik52
New member
1 0 0 0
Message 1 of 2
190
Flag Post

Reboot Issues

HP Recommended
HP All In One 27 xa0050
Microsoft Windows 10 (64-bit)

When I try to boot up from the off position, the DOS information pops up for about 5 seconds then the system goes into self repair. After a 5 minute or so recovery attempt, the blue screen pops up and states that an "Automatic Repair Failure"

With a message - Your PC did not start correctly - Then the screen gives me the option to Restart or use Advanced Options.

I have tried every possible scenario given to me and I cannot get the computer to reboot with windows 10. For the past couple of weeks, the computer has been slow to boot up after being shut off for a week or so.

Any help would be greatly appreciated. 

BMelnik52

1 REPLY 1
Prométhée
Level 16
Level 16
6,098 6,026 667 2,473
Message 2 of 2
Flag Post
HP Recommended

Hello
diagnose the computer
if you have an error id code give it here!

HP PCs - Testing for Hardware Failures | HP® Customer Support

 

Please remember to mark the answers this can help other users
please click on the accept as solution button if message provided an answer to the problem

was this reply helpful , or just say "thank you " ?  Click on the yes button



Desktop-Knowledge-Base
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation