-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Desktops
- Desktop Software and How To Questions
- The black screen saying Auto Resolution in process keep comi...

Create an account on the HP Community to personalize your profile and ask a question
12-26-2020 09:26 PM
Hi, I have HP w2207 monitor. The black screen of Auto Resolution in progress keep coming in the screen every few seconds please help me with this issue.
thank you
12-27-2020 08:13 AM
(auto response engine says) no PC told at all not even a clue, sure desktop but 10,000 models.
old monitors do that, when the inputs are wrong.
1680 x 1050 factory-set resolution and MAX TOO !!!!
if you connect this to PC that is set higher, the monitor fails. by going nuts or simple put this to the screen
OUT OF RANGE
some lamer monitors will just get lost or go black. seen it but is rare.
now the cure, put PC in SAFE ,mode and then set the resolution to above.
or use other monitor new to set lower reso, above, then put back old monitor.
your manual shows this. 18 valid resolution, only.
http://h10032.www1.hp.com/ctg/Manual/c00834092
SEE METHOD 4 HERE
https://www.wikihow.com/Activate-Safe-Mode-in-Windows-10
GO TO SAFE MODE OR PICK. OR ENABLE LOW RESOLUTION MODE, then when you have desktop set it to
1680 x 1050