cancel
Showing results for 
Search instead for 
Did you mean: 
dnlsk
New member
1 0 0 0
Message 1 of 2
924
Flag Post

management platform in manufacturing mode

HP Recommended
Z200 Workstation
Microsoft Windows 7 (64-bit)

I just installed an Intel Management Engine Firmware Update (sp81826) and my computer now displays a "management platform in manufacturing mode" message during bootup and when I boot into windows my computer shuts off by itself after about 30 minutes. Is there anything that can be done?

1 REPLY 1
Grzwacz
Level 12
Level 12
6,774 6,758 638 1,525
Message 2 of 2
Flag Post
HP Recommended

Greetings,

Welcome to the forum.

I am not a HP employee.

 

Have you tried setting the BIOS to defaults or clearing CMOS?

 

This is a firmware update, very hard to undo. Have you tried rolling back the BIOS to a previous version (link)? You have a workstation. The above link may not apply to your HP product. Try this Forum Board (link) for better results.

 

One other option would be to check HP Support for offline BIOS update media or BIOS rollback media.

 

Regards

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation