Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Locked

‎11-26-2021 02:27 PM

HP Recommended
Product: HP 25es Monitor

I recently got a new computer and tried setting it up with my old monitor. When I press the power button on the tower no start up screen appears. The only thing that is on the monitor is an error message that says Input Signal Not Found Check the video cable and video source. Display Going to Sleep. This appears for a few seconds then the screen goes black for a few seconds before it repeats. The monitor is a 25es. I'm not sure what the operating system is, but it should be either Windows 10 or 11. I use an HDMI cable and it was working fine when it was connected to the old computer.

Category:
1 REPLY 1

‎11-26-2021 04:19 PM - edited ‎11-26-2021 04:20 PM

HP Recommended

@JM7772 

 

How do you connect them ? What is your new computer ?

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No
Recommendations
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.