• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs, VIDEOS AND MORE.
Locked

‎09-21-2022 07:25 PM

HP Recommended
Product: HP 600 G2
Operating System: Microsoft Windows 10 (64-bit)

Hey HP, I have a HP Prodesk 600 G2 where I don't know where to plug in the bluetooth cable. I have tried to install the wifi card's manufacturer driver where Wi-Fi works fine but no sign of Bluetooth working.
There are 2 connector (pic as below) where i tried to plug in the Bluetooth Cable. 

I have also attached the picture of Bluetooth Cable from the Pcie wifi card along with motherboard model.

 

WhatsApp Image 2022-09-21 at 5.49.02 PM (1).jpegWhatsApp Image 2022-09-21 at 5.49.02 PM.jpegWhatsApp Image 2022-09-21 at 5.49.56 PM.jpegWhatsApp Image 2022-09-21 at 5.51.07 PM.jpeg

 

2 REPLIES 2

‎09-21-2022 10:21 PM

HP Recommended

@NPI 

 

What is your wifi+bluetooth combo adapter. All your images show very different thing and normally no antenna on your machine does it had wifi+BT before ? If no, you have to add antennas for new adapter. For example

 

               https://www.amazon.com.au/b?ie=UTF8&node=4913377051

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No

‎09-22-2022 08:11 AM

HP Recommended

Hi, @NPI 

 

The BT should work when you plug the cable into the SD RDR header.

 

That header is for the optional USB SD card reader.

 

You plug it in on using the pins on the left side of the header and leave the two remaining pins exposed.

 

That would be kind of top to bottom of the header in your screenshot.

1 person found this reply helpful
Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.