• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
HP Recommended

I have recently purchased an HP TouchSmart 610 PC for my office and I am trying to install a stand that attaches to the wall. I am having some trouble getting the tilt stand removed. Any suggestions would be helpful, a how-to guide would be greatly appreciated.

 

Thanks in advance.

5 REPLIES 5
HP Recommended
HP Recommended

FYI - after several hours surfing the web and a couple of calls to HP, i was told by parts that the 610 did not require a mounting kit and could be mounted as-is but they didn't know how.  Then I was told by Tech Support that the 610 could not be wall mounted (even though the box clearly states that it can).   I pressed them for a document, white paper, tech article, SOMETHING that showed how this was supposed to be done, and they couldn't find ANYTHING. 

 

That's right, HP doesn't know how to wall mount their own product.  If this forum is monitored/moderated, I hope someone takes this as an Action Item!  It was very frustrating.

 

Then, as I had the unit laying flat trying to remove the rear cover, I happen to notice that the bottom of the stand looked like a VESA mount compatible plate.  Turn it upside down and take a look.  That's how it's mounted!!

 

HP Recommended

Hey everyone.  I know this post is almost a month old, but I figured out the correct way to wall mount one of these Touchsmart 610's. 

 

1. If you look at the bottom surface of the tilt stand, you will see what cyberlopez6 described as a VESA mount compatible plate.  This is a removable wall plate.  Disconnect this plate by removing the 4 torx/flathead screws.

 

2. Next, after using a small flathead screwdriver to gently remove the plastic shroud around the back surface of the tilt stand, you will see 2 small philips screws that feel spring-loaded when you touch them.  Tighten these screws down all the way and slide the tilt stand upwards until you feel it lock into place about halfway up the back of the computer.

 

3. Now you can remove the 4 torx/flathead screws that are holding the tilt stand on.  Then use the same 4 screws to mount the wall plate which was removed from the bottom of the system. 

 

There you have it!  You're ready to mount this bad boy on the wall.  Enjoy!

 

Curt

HP Recommended

Is the back where the usb hubs are and power cable area still accessible when you mount the wall plate on? 

HP Recommended

Ok so we have attempted to screw the mounting plate onto the back as suggested above however we could only screw in the top two screws. The plate doesn't actually sit flush onto the rails because of the shape...still seems very secure though.

 

And the back area is accessible. 

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.